Your first steps with IQOS

Getting started with your IQOS 3

1. Push the button on your IQOS 3 Pocket Charger to check your battery level. When you see the lights, it's ready to use. If your Pocket Charger doesn't power up, hold down the button for four seconds or plug your device into a power outlet using an IQOS AC adaptor and cable.

2. Open the IQOS 3 Pocket Charger door, insert the Holder into the charger, then close. A flashing light will let you know it's charging.

3. When it's ready to use, gently insert a heatstick into your Holder without twisting your heatstick. Then press and hold the Holder button. One vibration and a slowly pulsing light mean it's getting ready. Two vibrations and both status lights turned on mean it's ready to use.

4. If your Holder light starts to fade, your IQOS 3 needs a charge. Slide open the Holder to remove the heatstick, and slide the Holder shut before you start to recharge using the IQOS AC adaptor and cable.

5. When you feel another two vibrations, your IQOS time is nearly up. Slide open the Holder, remove the heatstick, and slide the Holder shut. Tap the Holder button to see its status, remember that one light means you only have one use left before need of recharge.

Cleaning your IQOS 3

1. Wait for your IQOS 3 to cool down and take off the Cap.

2. Tap out any loose tobacco stuck inside your IQOS 3 Holder, then insert the cleaning tool. Once in, gently twist two or three times before carefully removing it.

3. Clean your device as often as you can. Remember to avoid the heating blade, and don't forget to clean the Cap top to bottom too. A cleaner device makes for a better taste experience. It's as simple as that.